Quick Start Guide
Step 1
Pachinko machines are top-heavy and can tip over easily. You should find some way to support the machine. I use two boards 1"x4"x10" and screw them to the bottom of the machine.
Step 2
Hooking up the lights in not needed for these machines to play. The lights flash when you get a jackpot. You can wire the lights to a 10 volt transformer or a 9 volt battery.
Step 3
Make sure the Feeder Line Stopper is in the up position. Otherwise balls can't roll down the track and enter the jackpot assembly.
Step 4
Check the Feeder Line Slide and make sure it is closed. If it is not closed, all the balls will flow from the top of your machine out the bottom.
Step 5
Make sure the right side of the Payout See-Saw is in the up position, using the Reset Plunger. On some models there is no Plunger so just use your hand.
Step 6
Load about 400 balls in the Feeder Tray.
Step 7
Load about 100 balls in the Play Tray.
Step 8
Place a bucket under the Won Ball Outlet and Lost Ball Outlet.
Step 9
To play, grasp the Finger Rest Bar with your fingers, place your thumb on the Playing Lever and snap the lever. You may have to do this a couple of times until the balls are loaded in the shooting position.
Step 10
When a ball goes in a Win Pocket, the lights will flash, and you will get 10 to 15 balls in your Play Tray depending on the particular manufacturer and model.
Step 11
If your Play Tray is full, then move your Play Tray Slider to the left and balls will flow into the Overflow Tray.
